AUTONET TV

Some New Boots (Suspension Maintenance)

There are some boots that don't come in a shoe box and aren't worn on your feet.  They are called axle or CV boots, and they can be important parts for many vehicles.

That CV stands for constant velocity.  CV axles are mainly used in front-wheel drive and all-wheel drive vehicles. They're also used in some rear-wheel drive vehicles with independent suspensions.  They have two CV joints, one inner and one outer, placed between the axle and the drive wheels.  That way the vehicle's engine power can drive the wheels, no matter what angle they are.  They also adjust for the different speeds wheels turn as they go around corners. 

Because roads are full of all sorts of hazards (dirt, oil, water, grime), these CV joints need to be protected.  They also have grease in them to keep the bearings moving smoothly.  That's the job of the rubber boots that are supposed to keep that debris out.  These CV or axle boots are made of rubber or plastic and usually last a long time without any problem.  But sometimes they fail, either from being hit by debris or age causing the rubber or plastic to deteriorate.  That can allow the grease to leak out of the joint and the moisture to get in.  And that's where the trouble is.

So it's important to have a vehicle's CV boots checked periodically, especially when they begin to have more than 100,000 miles/160,000 kilometers on them.  A technician inspects them for tears or cracks.  Sometimes if the problems are found early enough, the boots can be replaced and the joints can be re-packed with grease. 

But sometimes the CV joint can wear out even though the boot is intact.  When the CV joint fails, you might hear a grinding, humming or clicking noise and feel vibration.

Some of these can be difficult to access for service, so many service advisors will recommend replacing the joints and boots at the same time.  Just remember, new CV boots won't make a fashion statement, but they will keep your vehicle going down the road for years to come.

Union Street Automotive
175 W Union Street
Newark, NY 14513
315-331-2525
http://www.unionstreetautomotive.net

Objects in the Mirror (Rearview Mirror Safety and Maintenance)

You may remember a song that went, "Objects in the rearview mirror may appear closer than they are." While that was a song about life's lessons, there are a few things we should all know about how important rearview mirrors are to safe driving.

While new electronic devices are helping drivers be aware of surrounding traffic in high-tech ways, the good old rearview mirror is still a dependable way of letting you know what's around you.  There are usually 3 on each vehicle, 1 attached to the windshield inside and 2 attached outside on each of the front doors.

It's important that they be adjusted properly before you start driving (not while you're driving). Experts say the windshield rearview mirror should cover the area behind the vehicle while the outside mirrors should not simply duplicate that view but extend it to the sides, where blind spots normally are.

Your rearview mirrors must be able to hold the positions they're adjusted in; it there's play in them or they move around, you'll never be sure they're pointed in the direction that will let you see where traffic is.  The one on the windshield must be firmly attached.  If it won't stay where you want it, head to your service facility where they can tighten it or replace any parts necessary to let the mirror maintain its aim. If it has fallen off the windshield completely, a technician can reattach it with the proper adhesives or fasteners.  There may be electronics that need to be properly connected as well.

The outside mirrors cover your blind spots and they must be able to hold their adjustments, too.  Many adjust electronically; switches and motors can fail, electrical connections can detach or become corroded and the reflective glass can crack, discolor or develop a hazy fog.  A technician can diagnose and repair those problems and recommend any replacement parts you might need.  Mirrors that are adjusted manually also should be restored to proper working order in order for you to maintain this important rear visibility.

Drivers don't think about their rearview mirrors all that much.  On reflection, don't they deserve respect and care for the important job they do?

Union Street Automotive
175 W Union Street
Newark, NY 14513
315-331-2525
http://www.unionstreetautomotive.net

Get Where You're Going with Power Steering Service in Newark

Today we're going to talk about power steering service in Newark. If you took an informal poll around Newark you'd probably find that most vehicle owners have never heard of power steering service. That's not surprising. Even though power steering is standard on every vehicle, most people in Newark aren't aware that it needs periodic service.

If you're younger than a certain age, you've probably never driven a vehicle without power steering. To get an idea of the difference; if you've ever cut a board with a hand saw, you know it's a lot of work. Using a power saw is easy-peasy by comparison.

Without power steering, your arms have to do all the work to steer the wheels, and that's hard, especially around downtown Newark. That's why old cars had such big steering wheels: to get enough leverage to steer.

Most vehicles in Newark have a hydraulic power steering system. The serpentine belt from the engine powers a pump. The pump pressurizes the power steering fluid. This actuates a hydraulic cylinder that provides power to help steer.

Some vehicles in Newark use an electric pump to pressurize the fluid rather than a belt driven pump. We're also seeing vehicles with electric motors providing the power assist, not using power steering fluid at all. We'll see a lot more electric systems as more hybrids and electric vehicles hit the market.

At least for now, the vast majority of power steering systems use power steering fluid that needs to be serviced. The fluid needs to be changed for a couple of reasons. For one, it attracts moisture. Water has different hydraulic qualities than power steering fluid, and that makes a difference in steering performance. Water is also corrosive and can damage power steering components. The fluid also just gets dirty and needs to be changed. Removing the old fluid and flushing out the system gets rid of dirt and deposits. The clean, fresh fluid lubricates and provides better corrosion protection.

So ask your Newark service advisor at Union Street Automotive or check your owner's manual to see when power steering service is recommended. It'll extend the life of your power steering components.

Union Street Automotive
175 W Union Street
Newark, NY 14513
315-331-2525
http://www.unionstreetautomotive.net

In a Fog (Fogged Windows in Cold Weather)

It's bad enough in cold weather when ice and snow block your visibility.  Add to that fog on the inside of your windows and you could be driving blind.  So here are a few tips on how to keep your windows from fogging up when there's a chill in the air.

You probably know fog is really condensation, when moist, warm air meets a cold surface and turns to liquid.  If your windshield fogs up, you probably turn on your windshield defroster. Most defrosters blow heated air on the windshield glass to warm it up so it won't condense the moisture.  Many also turn on the air conditioning to reduce the moisture. 

That same strategy can work on the rest of the windows.  First, turn up your heater's temperature setting.  The hotter the air, the more moisture it will hold.  Also, turn off the "recirculating" setting since you want all outside air to come in. Then switch on the air conditioning.  It will remove the moisture from the outside  air that it's blowing inside the cabin.  Try cracking a couple of windows to make it easier for the air to flow. This should do the trick pretty quickly. 

There's one other thing to try.  Many vehicles have electric heater elements embedded in the rear window glass (the rear window defroster) and in the outside rearview mirror glass. Make sure to turn those on, too; sometimes they're on the same switch.

For all of these things to work, of course, your vehicle's components have to be maintained so they'll do the things they're designed to do.  And you didn't think it was important to have your air conditioning working in the cold weather months! 

One final tip.  Keep the insides of your windows CLEAN.  Oil and dirt on the glass give the water molecules something to latch on to.  That ought to clear up this problem.

Union Street Automotive
175 W Union Street
Newark, NY 14513
315-331-2525
http://www.unionstreetautomotive.net

Low Power Mystery (Ignition Coil Service)

It's no fun when your vehicle just doesn't run the way it used to.   You may notice (especially in cold weather) the engine won't start easily or when it does start, it doesn't run smoothly. It may not have much power at all. You also may have had to stop at the gas station more often, a sign your fuel economy isn't what it used to be. 

There could be a few different things that cause those symptoms, but one culprit could be a bad ignition coil. The coil takes the voltage from your battery and multiplies it before that power is sent over to a spark plug. That allows the plug to fire off a good jolt of electricity that ignites the fuel in your cylinder and powers the engine. 

There's usually one ignition coil for each cylinder (or sometimes for a pair of cylinders). If only one of them is not pushing out enough electricity, it can cause big trouble with your engine performance.  Other signs of a bad ignition coil include engine backfire, an oil leak and your Check Engine light coming on.   When that light comes on and you have some of those other signs, you need to have your repair facility check things out fairly soon because you may be damaging your engine and wind up with a far more expensive repair.

A technician will check for a computer code to pinpoint which cylinder is having the problem.  Using other diagnostics, the technician can rule out other components that might be causing the engine to misfire.  Ignition coils usually last 100,000 miles/160,000 km, but other engine conditions can cause them to fail before then. 

Your service advisor may suggest getting all your coils replaced even though only one is malfunctioning. That's probably a good idea in a higher mileage vehicle since the other coils may be close to failure, too. It's also wise to do that if your vehicle's coils are located in a hard-to-reach spot so you likely won't have to spend the money for that labor again when another one fails.

Union Street Automotive
175 W Union Street
Newark, NY 14513
315-331-2525
http://www.unionstreetautomotive.net